Texas weather is hard on outdoor wood. We clean, prep, and apply quality stains that penetrate deep into the wood grain — protecting your fence and deck from the inside out.
Untreated wood in East DFW doesn't last. The combination of intense UV, heat, and humidity swings dries out and breaks down wood fibers fast. Staining is the most cost-effective way to protect your outdoor wood and extend its life significantly.
Texas sun bleaches and dries out wood fast. A quality stain with UV inhibitors slows that process dramatically, keeping wood looking natural longer.
Water is wood's enemy. Penetrating stains seal the wood fibers from the inside, preventing moisture absorption that leads to warping, splitting, and rot.
A properly stained fence or deck lasts significantly longer than untreated wood. It's one of the most cost-effective ways to protect your outdoor investment.
Cedar and pine fences take a beating in Texas. We clean, prep, and apply a penetrating stain that soaks into the wood grain to protect from UV and moisture — not just coat the surface.
A properly stained deck lasts years longer and stays safer underfoot. We prep the surface, apply a quality stain, and seal it so water beads off instead of soaking in.
Prefer a solid color over a natural stain? We paint fences too. Proper prep and a quality exterior paint means a finish that holds up through seasons without peeling.
Grayed-out, weathered deck boards can often be restored without full replacement. We strip the old finish, brighten the wood, and apply fresh stain for a like-new result.
Pergolas and arbors are exposed on all sides. We stain and seal all surfaces — top, bottom, and sides — so the structure stays protected and looks great.
Before any staining or painting project, we power wash the surface to remove dirt, mildew, and old loose finish. Clean wood accepts stain better and the results last longer.
Proper prep is what separates a stain job that lasts from one that fails in a season.
We look at the current condition of the wood, check for rot or structural issues, and give you a straight quote for cleaning, prep, and staining.
Every staining job starts with a thorough power wash. We remove dirt, mildew, algae, and any old loose finish so the new stain can penetrate properly.
We let the wood dry completely before applying stain. Staining wet wood traps moisture and causes premature failure. We don't rush this step.
We apply a quality penetrating stain by brush, roller, or spray depending on the surface. We work it into the wood grain and back-brush for even penetration.
We walk the entire fence or deck with you to make sure coverage is even and complete. Any thin spots get touched up before we leave.
"Daltonn stained our cedar fence and it looks brand new. He power washed it first, let it dry, and applied a beautiful natural stain. The whole neighborhood has been asking who did it."
"Our deck was looking terrible — gray and weathered. Daltonn restored it completely. He stripped the old finish, brightened the wood, and applied a fresh stain. It looks better than when we built it."
"Had the fence and pergola stained at the same time. Great communication, showed up when he said he would, and the results are excellent. Very happy."
Get a free quote. We'll take a look at the condition of your wood and recommend the right stain and approach.